2026-07-21 · 4 min read
Toyota Alphard Service Schedule Malaysia (H30/H40)
Complete H30 and H40 Alphard service intervals — engine oil, 8AT/e-CVT fluid, spark plugs, dual cabin filters, inverter coolant (hybrid), hybrid battery fan. What to do at every km milestone.
Toyota Alphard H30 and H40 share similar service intervals for most items — but the hybrid variant adds two extra maintenance items: the inverter coolant circuit and the hybrid battery cooling fan. Follow this schedule to keep your Alphard in top condition in Malaysia's climate.
Every 10,000 km — Engine Oil & Filter
Change 0W-20 SP full synthetic engine oil and oil filter. For H30 2AR-FE: 5.0L. For H40 2.4T: 5.5L. Check tyre pressure, coolant level, brake fluid level, windshield washer fluid. This is the single most important interval — do not extend beyond 10,000 km in Malaysian heat.
Every 20,000 km — Cabin Filters + Door Lubrication
Replace front AND rear cabin filters. Clean door rail channels and apply silicone grease to the power sliding door rollers and rail — the most important preventive maintenance unique to Alphard. Check brake pad thickness. Inspect hybrid battery cooling fan duct for dust blockage (hybrid variant). Rotate tyres.
Every 30,000 km — Air Filter + Full Brake Inspection
Replace engine air filter. Full brake inspection: pad thickness, disc condition, caliper operation. Check power steering fluid level. Inspect all belts and hoses. Inspect front and rear evaporators for mould — chemical clean if needed. Check suspension bushings for wear.
Every 60,000 km — Spark Plugs, ATF/CVT Fluid, Brake Fluid
Replace all 4 iridium spark plugs. Change 8AT ATF WS or e-CVT Transaxle Fluid FV (whichever applies). Replace brake fluid (DOT 3 minimum). Inspect timing chain (listen for rattling on cold start). Inspect shock absorbers for leakage. Inverter coolant inspection for hybrid — full change every 160,000 km or 8 years.